搜索资源列表
freq_meter
- Frequency meter Verilog implementation for Xilinx XC2C256. MT10T7 7-seg LCD used for output.
seg
- 数码管显示（verilog） 自己写的 在数码管上显示01234567 动态显示-Digital LED display (verilog) himself wrote in the digital tube display 01234567 dynamic display
seg
- 用verilog语言实现数码管控制工作，有问题可以qq咨询，516998649-use the verilog language to drive the seg
verilogiic1121
- i2c的verilog程序，通过写入eeprom再读出并在seg数码显示管上显示来进行验证-i2c' s verilog program eeprom read by writing out and in the seg digital display tube display to verify
seg
- verilog编写的时钟分频程序和数码管显示程序-verilog
seg
- 这是用verilog 编写的静态数码管实验，初级，实用，挺好的例程-It is written in verilog static digital test, primary, practical, very good routine
74HC595-seg
- 基于verilog语言的74HC595程序。两块74HC595联级使用-Based on the Verilog language 74HC595 procedures
8-SEG-LED-Board
- 基于FPGA的EPM 1270芯片开发板的8 SEG LED Board Verilog程序，已通过测试，能正常使用，引脚已配好。-Based the EPM 1270 chip FPGA development board 8 SEG LED Board Verilog program has been tested normal use, the pin with a good.
seg
- 大西瓜FPGA开发板陪赠资料\大西瓜FPGA开发板例程（基础+进阶）\开发板基础实验\开发板基础实验---数码管的动态显示。Verilog -Watermelon FPGA development board to accompany gifts Data \ the watermelon FPGA development board routines (foundation+ Advanced) \ basic experimental development board \ basic ex
SEG
- 采用DE2 实现数码管递增 VERILOG-Using DE2 achieve the digital pipe incremental VERILOG
SEG7lED
- 基于verilog的7段数码管显示控制，实现数字显示。-7 seg led displaying control based on verilog
key
- PS2键盘协议代码 verilog，可以在ISE上跑，约束条件：NET"F50M" LOC="B8" NET"ps2_clk" LOC="R12" NET"ps2_data" LOC="P11" NET"rst" LOC="H13" NET"seg[6]" LOC="L18" NET"seg[5]" LOC="F18" NET"seg[4]" LOC="D17" NET"seg[3]" LOC="D16" NET"seg[2]" LOC="G14"
SegSimplified
- 本工程使用verilog HDL和vivado2014集成开发环境实现利用xilinx Basys3开发板上4位数码管显示从0到9999的计数器功能。-This project uses verilog HDL to realise counting 0 to 9999 on the 7-seg LED loaded on Xilinx Basys3 board.
traffic-light-Verilog
- 交通灯分为X组和Y组，每组包括了2位倒计时数码管和红黄绿三色LED信号灯（每组包括﹢、-两小组，显示内容一样），考虑到应用需求，要求芯片可通过I2C接口连接到上位机，以调节内部控制寄存器,此为Verilog代码，包含led、seg、timer等模块。-Traffic lights are divided into groups X and Y groups, each including two digital countdown yellow-green and red LED lights
BCDto7seg
- bcd to 7 seg code in verilog
seg
- 基于verilog语言的74HC595程序,适用于驱动单个四位数码管(Four bit digital tube driver)